Hi Scotty when I hook my bluedriver to my 2006 Holden comodoore VZ in mode6 it says minimum sensor voltage for test cycle bank 1 sensor 2 and it reads 0.00V. If I go arround the block then it says it's working as normal can you please tell me what this might mean and what to do about it. Also I tried to measure the voltage with a multimeter but I couldn't find that end of the oxy sensor?

realize software on that machine is not going to be as accurate as an oscilliscope which I use when I analyze them as a pro mechanic. Even a multimeter is not good enough to accuracy on that

Does that mean you suspect the blue driver is reading it in correctly? That would make sense because the check engine light hasn't come on