Remember slap bracelets from way back when? Now you can make your own (and get kids to help) with just a few supplies. It’s really fun to make your own jewelry.
DIY SLAP BRACELETS
Here’s what you need to make DIY Slap Bracelets:
- Measuring Tape (the kind you buy at the hardware store)
- Screw Driver
- Duct Tape
Use the screw driver to remove the outer casing of your measuring tape. Cut off the metal end of the tape and then cut a piece that is 6 inches long. You’ll need a 6-inch piece for each slap bracelet that you want to make.
Use the scissors to round the edges of the piece of measuring tape.
Curl the tape back onto itself, bending it back so that it rolls with the numbered side up. You’ll start to feel it become more malleable. You’ll know it’s ready when you can slap it onto your wrist and it wraps around it!
Cut a piece of duct tape just larger than your bracelet. Lay it onto the numbered side of your measuring tape, and wrap it around the tape to the back side. Cut a smaller piece to cover the remaining bracelet on the underside.
Now your bracelets are ready to use! Time to start slapping!