Stethoscope Cover

Have a budding doctor at home? Want to personalize their Stethoscope and embarrass them at work? Learn to create a cover for their Stethoscope!

by CraftBits (Shellie Wilson)

What you need

34 inch x 6.5 inches (86cm x 16.5 cm) of Fabric
1 inch square of Velcro or a press stud
2.5 inches (6cm) of Elastic


Start by taking your length of fabric. Hem the 2 smaller edges for a neat finish. Fold it in half so that it is inside out (the print is facing inwards).

Following the steps in the image below, sew along the edge to close the strip to form a tube.

Take the elastic and sew it into place at end “A” by sewing it into place around 1/2 (1.5 cm) inch from the edge.

Using glue or sewing machine secure your Velcro into place by stitching one side of the Velcro to each side of the tube. This will stop the fabric from sliding down the stethoscope.

You could also substitute the Velcro for a press stud if you wish it depends on your sewing skills as to how you wish to tackle this project.

Once you have finished turn it the right way around so that the print is facing out.

Then thread it over your stethoscope with the elastic at the bottom and the press stud at the top.

All done!

Have You Seen These Ideas?